Skip to content

STEP Controls™ Print E-mail
Image
DIGI-LUX™ Thermostat
The STEP Warmfloor™ heating elements are self-regulating and cannot overheat; therefore it is as if you had a sensor over the whole floor surface. Although the heating system does not require a control unit, except for an on/off switch, you may want to install a controller or regulator for the following reasons:
  • Not everyone has the same temperature comfort needs
  • You may want to keep some rooms warmer than others
  • You want to keep the floors warm and not rely on the ambient temperature
  • When the house is not in use you may not need much heat, but you do not want to risk the water tubing to freeze
  • You are aware of energy efficiency and want to keep the cost down

Recommended Controllers
MICROREG CONTROLLER (MICROREG)
Electronic power controller with relay output for infinitely variable setting of requested heating output, up to 10A.
DIGI-LUX CONTROLLER (DIGI-LUX, DIGI-Therm, DIGI-Reg-1, DIGI-Reg-2)
Electronic Thermostat/Regulator combination (DIGI-LUX) used for zone control of STEP Warmfloor™ system. Thermostat (DIGI-Therm) can be flush wall mounted in single gang box. Each Regulator can control up to 2,500W of connected load. Up to three additional Regulators (DIGI-Reg-2) can be connected to first Regulator (DIGI-Reg-1) to allow for group control of up to 10,000W of connected load.

Alternative Controllers
  • On/Off Switch
  • Dimmer, heavy duty, single pole, designed for low-voltage, magnetic transformer. Choose a dimmer size two times larger than the capacity of the transformer.


Related Links...
 
Next >
[ Back ]

Getting Started

Did You Know?

STEP Warmfloor™ is the most energy efficient heating available because the material itself is self-regulating and only draws the energy it needs to maintain an even temperature on the whole surface.  The heating elements cannot overheat.