Skip to content

Home
Little Help
 

Login with username, password and session length
November 22, 2008, 06:38:14 AM
Pages: [1]
« previous next »
  Print  
   Author Topic: Little Help  (Read 1122 times)   
whynot
Newbie
*
Posts: 1


View Profile
« on: November 21, 2007, 10:52:11 PM »
I have a two part question.  I'm renovating my master bath & installing the Warmfloor as the sole heating source for the room.  I have 5/8" plywood subfloor & I placed 1/2" Hardi backer board on top of that & will install 18"x18" marble tile as the finished floor.  I was told the closer I have the heating elements to the tile the better or warmer the tile will be.  Question 1.  Should I put the elements on top of the 1/2" Hardi board & then thinset the tile on top of the elements or should I first thinset another layer of 1/4" Hardi board before the tile?  This way the elements are sandwiched in between the two layers of Hardi board. I"m sure the tile guy will prefer this so he is working on a smooth floor.

Question 2.  What is the best way to fix the elements to the Hardi board?  Staples won't due.  Someone suggested duct tape.  Can I nait it down maybe with galvanized roofing nails?  Any suggestions will be appreciated.
Logged
Tim
Technical Support
Newbie
*****
Posts: 22


View Profile
« Reply #1 on: December 03, 2007, 05:07:44 PM »
Sorry to leave your question hanging...

First, it would be wrong of me to not mention that it sounds like you may need more subfloor than that for a sturdy tile installation.  Your tile guy should know better than I do so you may want to ask him about that...

As far as question 1: (if you haven't already done the job) you should be fine either way.

And for question #2:  Thinset is always your best bet when you're doing a tile floor.  There is no possibility of creating a short in the circuit with thinset.

Thinset, Thinset, Thinset.
Logged
 
Pages: [1]
  Print  
« previous next »
 
Jump to:  

Powered by SMF 1.1.2 | SMF © 2006-2007, Simple Machines LLC

Getting Started

Did You Know?

Indoor Air Quality is directly correlated with respiratory illness.  The last thing you want your mechanical system to do is to distribute dust, mold spores, pollen, and other particulates throughout the structure. Because radiant heat does not blow allergens, it helps those with allergies and asthma find dramatic improvement to their symptoms.